Никак не могу записать созданный образ на DL диск. мои действия:
genisoimage -f -v -udf -o obraz.iso /home/svl/Загрузки/Безымянная\ папка/пошел процесс:
....
49.49% done, estimate finish Sat Apr 12 11:07:25 2014
....
99.83% done, estimate finish Sat Apr 12 11:08:08 2014
Total translation table size: 0
Total rockridge attributes bytes: 0
Total directory bytes: 229528
Path table size(bytes): 1568
Done with: The File(s) Block(s) 2938523
Writing: UDF Anchor end volume Start Block 2939799
Done with: UDF Anchor end volume Block(s) 1
Writing: UDF Pad end Start Block 2939800
Done with: UDF Pad end Block(s) 150
Max brk space used d4000
2939950 extents written (5742 MB)образ получен:
~$ ls -l
-rw-r--r-- 1 svl svl 6021017600 Апр 12 11:08 obraz.iso
~$ sudo wodim --devices
[sudo] password for svl:
wodim: Overview of accessible drives (1 found) :
-------------------------------------------------------------------------
0 dev='/dev/sg1' rwrw-- : 'TSSTcorp' 'CDDVDW TS-L633C'
-------------------------------------------------------------------------на резаке указана поддержка записи DL
~$ sudo wodim dev=/dev/sg1 -eject -v speed=4 obraz.iso
wodim: No write mode specified.
wodim: Assuming -tao mode.
wodim: Future versions of wodim may have different drive dependent defaults.
TOC Type: 1 = CD-ROM
scsidev: '/dev/sg1'
devname: '/dev/sg1'
scsibus: -2 target: -2 lun: -2
Linux sg driver version: 3.5.34
Wodim version: 1.1.11
SCSI buffer size: 64512
Device type : Removable CD-ROM
Version : 5
Response Format: 2
Capabilities :
Vendor_info : 'TSSTcorp'
Identification : 'CDDVDW TS-L633C '
Revision : 'AC01'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x002B (DVD+R/DL)
Profile: 0x0015 (DVD-R/DL sequential recording)
Profile: 0x0016 (DVD-R/DL layer jump recording)
Profile: 0x002B (DVD+R/DL) (current)
Profile: 0x001B (DVD+R)
Profile: 0x001A (DVD+RW)
Profile: 0x0014 (DVD-RW sequential recording)
Profile: 0x0013 (DVD-RW restricted overwrite)
Profile: 0x0012 (DVD-RAM)
Profile: 0x0011 (DVD-R sequential recording)
Profile: 0x0010 (DVD-ROM)
Profile: 0x000A (CD-RW)
Profile: 0x0009 (CD-R)
Profile: 0x0008 (CD-ROM)
Profile: 0x0002 (Removable disk)
Using generic SCSI-3/mmc DVD-R(W) driver (mmc_mdvd).
Driver flags : SWABAUDIO BURNFREE
Supported modes: PACKET SAO
Drive buf size : 1439744 = 1406 KB
Beginning DMA speed test. Set CDR_NODMATEST environment variable if device
communication breaks or freezes immediately after that.
FIFO size : 12582912 = 12288 KB
Track 01: data 5742 MB
Total size: 6594 MB (653:19.33) = 2939950 sectors
Lout start: 6594 MB (653:21/25) = 2939950 sectors
Current Secsize: 2048
HINT: use dvd+rw-mediainfo from dvd+rw-tools for information extraction.
Blocks total: 4173824 Blocks current: 4173824 Blocks remaining: 1233874
Speed set to 5540 KB/s
Starting to write CD/DVD at speed 4.0 in real unknown mode for single session.
Last chance to quit, starting real write in 0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
Errno: 5 (Input/output error), reserve track scsi sendcmd: no error
CDB: 53 00 00 00 00 00 2C DC 2E 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 72 0B 00 00 00 00 00 0E 09 0C 00 00 00 02 00 00
Sense Key: 0x0 No Additional Sense, Segment 11
Sense Code: 0x00 Qual 0x02 (end-of-partition/medium detected) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 40.969s timeout 40s
wodim: Cannot open new session.
Writing time: 46.467s
wodim: fifo had 191 puts and 0 gets.
wodim: fifo was 0 times empty and 0 times full, min fill was 100%.я предположил, что не те диски использую, открыл новую упаковку, результат тот же.
